HP s510 manual Appendix, Troubleshooting, About Folder and File Names

Appendix

About Folder and File Names

Your camera automatically creates specific directory of folder in the internal memory cards to organize captured photos, videos and audio files.

File Naming

File names begin with "DSCI" and followed by a 4-digit number that increases in sequence. File numbering starts from 0001 when a new folder is created.

If the highest folder number is 999 and the highest file number exceeds 9999, the camera will display the warning message "Folder cannot be created". When this happens, try one of the following ways:

•Reset the file number. See "Setting File Numbering" on page 58.

Do not change the folder and file names in the memory card using your PC. It may be unable to playback the data using the camera.

Troubleshooting

Problem		Cause and/or Action
Camera does not turn on.	∙	The battery may not be loaded correctly.
	∙	The battery may be exhausted. Charge or replace the battery.
Camera turns off	∙	Power Saving may have activated. Turn power back on.
automatically.	∙	The battery may be dead. Charge the battery.
Power will not turn off.
Nothing happens when a	Remove the battery from the camera and then reload it.
button is pressed.
LCD turns dark.	Press any button except the Power button to turn on the LCD.
Empty battery icon is
displayed on the LCD, then	Battery is exhausted, please replace or recharge.
the camera turns off.
LCD monitor displays	There is no photo file in the memory card. Photo file format may not be
"No image".	supported.
LCD monitor displays	Function is only available for specific file types. File format is not
"Not available for this file".	supported.
LCD monitor displays	Memory card is full. Replace the memory card with a new one or delete
"Memory full".	unnecessary photo/video/audio clips.
LCD monitor displays	This file is locked. Unlock the file. See "Protect" on page 48.
"File locked"
LCD monitor displays	The memory card is protected. Remove the card and slide the
"Card locked".	write-protect switch to its unlock position.
LCD monitor displays	The card may be damaged. You can either change the card or wipe to
"Format error".	clean the connected points.
LCD monitor displays	The memory card is protected. Remove the card and slide the
"Card error".	write-protect switch to its unlock position.
No photo displays on the	Incorrect TV-out type was selected. Set the correct TV-out type to match
TV screen.	your TV system.
The lens is stuck and will	Do not force the lens to go back.
	The type of the battery used may be incorrect or the battery power level
not retract or extend..	is too low. Change the battery or charge the battery before using the
	camera.
		63