HP Serviceguard Extension for SAP (SGeSAP) manual Installation Step IS049

...> param_directget RUNDIRECTORY

OK

RUNDIRECTORY /sapdb/data/wrk/<DBSID>

---

...> param_directput RUNDIRECTORY /sapdb/<DBSID>/wrk

OK

---

...>

Installation Step: IS049

If it does not yet exist, create a CVM/CFS system multi-node package and start it.

Integrate all SAP related CFS disk groups and file systems. The package dependencies to the system multi-node package get created automatically. The mount points need to be created manually on all alternate nodes first.

Here is an example for a disk group that was created with the following command sequence:

vxdg -s init dgC11 /dev/rdsk/c4t0d4 vxdg -g dgC11 set activation=sw

vxassist -g dgC11 make /dev/vx/rdsk/dgC11/cfs01 newfs -F vxfs \ /dev/vx/rdsk/dgC11/cfs01

In order to put it into the Serviceguard cluster, the following command sequence is needed:

cfscluster config cfscluster start cfsdgadm add dgC11 all=sw

cfsmntadm add dgC11 cfs01 /usr/sap/<SID> all=rw

After these conversions, it should be possible to start the SAP System manually. If the installation was done using virtual IPs, then the additional packages defined in that step need to be started after starting the CFS packages, but prior to the SAP manual start.

HP-UX Configuration 47