Abstract, Part Number Published | HP SL500 (M852x) instruction

SL500 (M852x) Tape

Library Installation and

User’s Guide

Abstract

This manual describes how to install and use an M852x tape library on HP NonStop™ servers.

Product Version

N.A.

Supported Release Version Updates (RVUs)

This publication supports G06.31 and all subsequent G-series RVUs and H06.11 and all subsequent H-series RVUs until otherwise indicated by its replacement publication.

Part Number	Published

541531-006	June 2007

Image 1

HP SL500 (M852x) manual Abstract, Product Version Supported Release Version Updates RVUs, Part Number Published

Contents

Abstract Product Version Supported Release Version Updates RVUsPart Number Published Document History Part Number Product Version Published Overview of the Tape Library SL500 M852x Tape Library Installation and User’s Guide Cartridge Information Tables Figures Contents Manual Information What’s New in This ManualNew and Changed Information Document HistoryPage Notation Conventions About This ManualHypertext Links Change Bar Notation Viii This section includes Overview of the Tape Library Front View of Tape Library Components Views and Locations Back View of Tape Library Components Physical Configurations Base Module Slots Slots Locations for Firmware Slot Mapping Slots Locations for Scsi Element Numbering Mapping Slot Capacity for Back Wall of Cartridge Expansion Module Capacities CAP Robotics Unit Robotics Components Hand Assembly Fans ElectronicsRLC Card Interface Cards Cartridge Access Port Power SystemCAP Condition Specification Performance LTO Generation 3 SpecificationsSupported Tape Drives LTO Ultrium Cards and Power Supply Safety FeaturesAudit of Tape Library Robotics 10. Tape Library Interfaces Locations Interfaces Power Switch Controls and IndicatorsKeypad Buttons and Indicators Buttons/Indicators Description Keypad Buttons and IndicatorsIndicator ButtonPage Opening the Front Door With Power Automated ModeSecuring the Front Door With Power Library Operation Sliding a Magazine Into a CAP Powering Off the Tape Library Powering On the Tape Library Opening the Front Door Without Power Manual Mode Door Locking Lever Extended Securing the Front Door Without Power Insert Cartridges Into Slots Locate and Remove Cartridge Inserting Cartridges Into Slots Inserting Cartridge Into Tape Drive Inserting a Cartridge Into a Tape Drive Location of Unload Button Removing a Cartridge From a Tape Drive Removing a Cartridge From the Gripper Assembly Manual Release Screw Replacing a Cleaning CartridgePage Handle Cartridges Cartridge InformationInspect Cartridges Maintain Cartridges Apply Cartridge Labels Ultrium CartridgesValid Labels Label Type of Cartridge LTO Cartridge Codes Ultrium Cartridge Label Write-Protect Switch Setting the Write-Protect Switch Specification L3 Cartridge L2 Cartridge L1 Cartridge LTO Gen 1, Gen 2, and Gen 3 Cartridge SpecificationsPage Adding the Control Path and the Data Path Supported ConnectionsServerNet/DA To add the data path PMF CRU PMF CRU Adding the Control Path and Data Path Supported Connection To add the data path SCF, issue this command Configuration Overview Series Rear View System Configuration Example Fiber-optic Adding the Control Path and Data Path Page Figure A-1. Library and Rack Dimensions Specifications Figure A-2. Tape Library and Rack Dimensions Table A-1. Library Component Weights Tape Library Components WeightsTable A-2. Library Environment Specifications Tape Library Environment Power Cord Numbers and Receptacles PowerTable A-3. Power Cord and Receptacles Table A-4. Non-Country-Specific Cords Installing the Power Cords Figure A-3. Power Cabling Table A-5. Power for Library Without Tape Drives Power SpecificationsTable A-6. Power for Base Unit and Two LTO Tape Drives Page Regulatory Compliance Statements Safety and ComplianceFCC Compliance Canadian Compliance Statements-2 Laser Compliance European Union Notice Safety Caution High Leakage Current Waste Electrical and Electronic Equipment Weee Safety