Step 7: Secure the drive
Note The server latches and side views of your server model may not be exactly the same as shown in the illustrations. Please refer also to you server documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in “Step 4: Attach mounting hardware” on page 15. The server also incorporates a locking mechanism to hold the tape drive in place.
1Push the server latch down to lock the tape drive into position, as shown in Figure 8a.
2Replace the cover on the server.
No mounting hardware used (HP AlphaServer)
1Use the M3 screws provided with the tape drive to secure it in place. Check that the holes in the chassis are aligned with the holes in the sides of the drive and use a regular Phillips screwdriver to secure the M3 screws, as shown in Figure 8b.
2Replace the cover on the server.
21
