Table Of Contents, Product Specifications, And Type, 8-13

6.	When cleaning, repairing or inspecting the snow thrower,	Clearing a Clogged Discharge Chute
	stop the engine and make certain the collector/impel-	Hand contact with the rotating impeller inside the discharge
	ler and all moving parts have stopped. Disconnect
	ler and all moving parts have stopped. Disconnect	chute is the most common cause of injury associated with
	the spark plug wire and keep the wire away from the	chute is the most common cause of injury associated with
	the spark plug wire and keep the wire away from the	snow throwers. Never use your hand to clean out the dis-
	plug to prevent someone from accidentally starting the	snow throwers. Never use your hand to clean out the dis-
	plug to prevent someone from accidentally starting the	charge chute. To clear the chute:
	engine.	charge chute. To clear the chute:
7.	Do not run the engine indoors, except when starting	1.	SHUT THE ENGINE OFF!
	the engine and for transporting the snow thrower in or	2.	Wait 10 seconds to be sure the impeller blades have
	out of the building. Open the outside doors; exhaust		stopped rotating.
	fumes are dangerous.	3.	Always use a clean-out tool, not your hands.
8.	Exercise extreme caution when operating on slopes.	3.	Always use a clean-out tool, not your hands.
8.	Exercise extreme caution when operating on slopes.	Maintenance and Storage
9.	Never operate the snow thrower without proper guards,	Maintenance and Storage
	and other safety protective devices in place and work-	1.	Check shear bolts and other bolts at frequent intervals
	ing.		for proper tightness to be sure the equipment is in safe
10.	Never direct the discharge toward people or areas		working condition.
	where property damage can occur. Keep children and	2.	Never store the machine with fuel in the fuel tank
	others away.		inside a building where ignition sources are present
11.	Do not overload the machine capacity by attempting		such as hot water heaters, space heaters, or clothes
	to clear snow at too fast a rate.		dryers. Allow the engine to cool before storing in any
12.	Never operate the machine at high transport speeds		enclosure.
12.	Never operate the machine at high transport speeds	3.	Always refer to operator’s manual for important details
	on slippery surfaces. Look behind and use care when	3.	Always refer to operator’s manual for important details
	operating in reverse.		if the snow thrower is to be stored for an extended
13.	Disengage power to the collector/impeller when snow		period.
13.	Disengage power to the collector/impeller when snow	4.	Maintain or replace safety and instruction labels, as
	thrower is transported or not in use.	4.	Maintain or replace safety and instruction labels, as
14.	Use only attachments and accessories approved by		necessary.
14.	Use only attachments and accessories approved by	5.	Run the machine a few minutes after throwing snow
	the manufacturer of the snow thrower (such as wheel	5.	Run the machine a few minutes after throwing snow
	weights, counterweights, or cabs).		to prevent freeze-up of the collector/impeller.

15.Never operate the snow thrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk; never run.

16.Never touch a hot engine or muffler.

CONGRATULATIONS on your purchase of a new snow	PRODUCT SPECIFICATIONS
thrower. It has been designed, engineered and manufac-	Gasoline Capacity	4.0 Quarts (3,79 Liters)
tured to give best possible dependability and performance.	and Type:	Unleaded Regular only
Should you experience any problem you cannot easily
Should you experience any problem you cannot easily	Oil Type	SAE 5W-30 or 10W-30
remedy, please contact your nearest authorized service	Oil Type	SAE 5W-30 or 10W-30
center. We have competent, well-trained technicians and	(API SG–SL):	(0° to +40°F)
the proper tools to service or repair this unit.		SAE 0W-30 (below 0°F)
Please read and retain this manual. The instructions will
Please read and retain this manual. The instructions will	Oil Capacity:	26 Ounces (0,74 Liters)
enable you to assemble and maintain your snow thrower	Oil Capacity:	26 Ounces (0,74 Liters)
properly. Always observe the “SAFETY RULES”.
properly. Always observe the “SAFETY RULES”.	Spark Plug:	Champion RN4C
	Spark Plug:	Champion RN4C
SERIAL NUMBER: ___________________________	Gap:	0.030" (0,762 mm)
SERIAL NUMBER: ___________________________
DATE OF PURCHASE: _______________________
DATE OF PURCHASE: _______________________	CUSTOMER RESPONSIBILITIES
THE MODEL AND SERIAL NUMBERS WILL BE FOUND	CUSTOMER RESPONSIBILITIES
THE MODEL AND SERIAL NUMBERS WILL BE FOUND	• Read and observe the safety rules.
ON A DECAL ATTACHED TO THE REAR OF THE SNOW	• Read and observe the safety rules.
ON A DECAL ATTACHED TO THE REAR OF THE SNOW	• Follow a regular schedule in maintaining, caring for
THROWER HOUSING.	• Follow a regular schedule in maintaining, caring for
THROWER HOUSING.	and using your snow thrower.
	and using your snow thrower.
YOU SHOULD RECORD BOTH SERIAL NUMBER AND	• Follow the instructions under “Maintenance” and “Stor-
DATE OF PURCHASE AND KEEP IN A SAFE PLACE	age” sections of this owner’s manual.
DATE OF PURCHASE AND KEEP IN A SAFE PLACE
FOR FUTURE REFERENCE.

SAFETY RULES	2-3
PRODUCT SPECIFICATIONS	3
CUSTOMER RESPONSIBILITIES	3
ASSEMBLY / PRE-OPERATION	4-7
OPERATION	8-13
MAINTENANCE SCHEDULE	14

MAINTENANCE	14-15
SERVICE AND ADJUSTMENTS	16-18
STORAGE	18
TROUBLESHOOTING	19
REPAIR PARTS	20-38
3 WARRANTY	BACK PAGE

Husqvarna 1130SB Table Of Contents, Product Specifications, Customer Responsibilities, and Type

Models: 1130SB

Clearing a Clogged Discharge Chute

Maintenance and Storage

PRODUCT SPECIFICATIONS

Gasoline Capacity

and Type:

Oil Type

(API SG–SL):

Oil Capacity:

Spark Plug:

CUSTOMER RESPONSIBILITIES

TABLE OF CONTENTS

8-13

14-15

16-18

20-38

3 WARRANTY

BACK PAGE