Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 11 Bio/13 H Bio Restoring from service position, MAINTENANCE RIDER 11/11 BIO, English

Models: 11 Bio/13 H Bio

1 43

Download 43 pages 52.23 Kb

Page 30

Image 30

MAINTENANCE RIDER 11/11 BIO

7.Lift off the drive belt (1). Then pull out the pin

(2).

Take care not to get your hand trapped.

8.Pull the frame forwards and insert the pin.

9.Grasp the front edge of the cutting unit, pull out and raise into the service position.

Restoring from service position

To restore the machine from the service position, reverse the sequence “Placing in Service position“.

English – 29

Page 30

Image 30

Husqvarna 11 Bio/13 H Bio manual Restoring from service position, MAINTENANCE RIDER 11/11 BIO, English

Contents

101 Rider 11/13 H Rider 11 Bio/13 H BioOperator´s manual IMPORTANT INFORMATION CONTENTS Operator’s Manual for Rider 11 and Rider 13 HRider 11 Bio and Rider 13 H Bio Travel and transport on public roadsEXPLANATION OF SYMBOLS Read the instructions before starting the machine SAFETY INSTRUCTIONSGeneral use Clear the area from stones etc. before cuttingDo as follows Be extra careful when driving on slopesDriving on slopes Cut slopes upwards and downwards, not sidewaysKeep children away from the mowing area MaintenanceChildren Never allow children to drive the machinebattery can explode and cause severe injuries Clean the machine regularly from grass, leaves and other wasteSAFETY INSTRUCTIONS before starting the engine. If fuel is spilt on clothes, change themPRESENTATION PresentationLocation of the controls Clutch pedal PRESENTATION RIDER 11 / 11 BIOThrottle and Choke lever Brake pedal / Parking brakeParking brake PRESENTATION RIDER 13 H / 13 H BIOSpeed limiter Throttle and Choke leverRider 11 Bio and Rider 13 H Bio have a twin-blade Cutting unitLift lever for cutting unit Lifting of the cutting unit transport positionFuelling Lever for adjustment of cutting heightSeat Rider 13 HStarting the engine DRIVINGBefore starting Rider 13 HDRIVING Cold engineWarm engine 5. Set the throttle control midway between position 1 andFor Rider 11 and Rider 11 Bio Driving the machine2. For Rider 13 H and Rider 13 H Bio The clutch must be used for each gear changeDRIVING Cutting tipsMowing pattern IMPORTANT INFORMATIONRelease lever Rider 13 H and Rider 13 H Bio Hill start, manual gearboxStopping the engine DRIVINGMaintenance interval MAINTENANCEMaintenance schedule MaintenanceFront hood Rider 11 and Rider 13 H Dismantling of the machine hoodsEngine hood Front hood Rider 11 Bio and Rider 13 H BioMAINTENANCE Right-hand fenderLeft-hand fender Release the screws in the fender and lift off the fenderChecking of the fuel pump’s air filter Check the engine’s oil levelCheck the engine’s cooling air intake MAINTENANCEChecking and adjustment of the steering wires MAINTENANCEPoorly adjusted brakes can result in reduced braking power Adjusting the brake Rider 11 and Rider 11 BioCheck and adjust the brakes on Rider 13 H and Rider 13 H Bio Checking the brake Rider 11 and Rider 11 BioProcedures on contact with acid Check the level of the battery acidCheck the safety system Check the transmission’s oil level Rider 13 H and Rider 13 H BioMAINTENANCE Do not use compressed air to clean the paper filterReplacing the air filter IMPORTANT INFORMATIONChecking the cutting unit’s parallelism MAINTENANCEAdjustment of the cutting unit’s parallelism MAINTENANCEMAINTENANCE RIDER 11/11 BIO Service position for BioClipPlacing in service position MAINTENANCE RIDER 11/11 BIO 5. Disengage the spring from the drive belt tensioning wheel7. Lift off the drive belt 1. Then pull out the pin Restoring from service positionMAINTENANCE RIDER 11/11 BIO Take care not to get your hand trappedCutting unit rear ejection Bio Checking the bladesChecking the tyre pressure MAINTENANCELubrication of front wheel bearings Changing the oilLubrication Rider 11 and Rider 11 Bio Check that the lock-ring is correctly posi- tioned in the slotMAINTENANCE Lubrication of belt tensionerGeneral lubrication 32 - EnglishChecking and adjustment of the throttle wire Replacement of the fuel filterMAINTENANCE TROUBLE SHOOTING SCHEDULE ProblemProcedure Service STORAGEWinter storage Rider TECHNICAL DATADimensions Rider 13 HTECHNICAL DATA Rider 11 BioRider 13 H Bio DimensionsEU declaration of conformity Only applies to Europe Directive 89/392/EEC, Annex II, ASvenska ´*3,¶6X¨ Svenska 2000W37 ´*3,¶6X¨