MAINTENANCE
Changing the oil
The oil should be changed for the first time after 5 hours of running time. Thereafter it should be changed every 25 hours of running time.
!WARNING!
Engine oil can be very hot if it is drained off directly after the engine is stopped. Therefore allow the engine to cool down first.
1.Place a receptacle under the engine’s drain plug, located on the
2.Remove the dip stick and drain plug.
3.Let the oil run out into the receptacle.
4.Fit the drain plug and tighten.
5.Fill up with oil to the “FULL” mark on the dip stick. The oil is filled in the same hole for the dip stick.
Use engine oil SAE 30 or SAE 10W/30, class
Use engine oil with min. API SF quality and SAE 30 or SAE 10W/30 viscosity grade. The oil volume in the engine is 1.4 litres.
6.Run the engine warm and then check that there is no leakage from the drain plug.
Lubrication Rider 11 and Rider 11 Bio
All joints and bearings are lubricated on manufac- ture with molybdenum sulphide grease.
The machine should be lubricated regularly, and when it is used daily twice a week.
Lubrication of front wheel bearings
On Riders with rear ejection the hood and wings must be removed so that the bar can be raised to allow removal of the wheel.
1.Remove the plastic cover on the hub.
2.Remove the
3.Lift off the wheel.
4.Grease the axle journal with molybdenum sulphide grease.
5.Assemble the parts in the reverse order.
IMPORTANT INFORMATION
Check that the lock-ring is correctly posi- tioned in the slot.
| ADD | FULL |
ADD | FULL |
|
IMPORTANT INFORMATION
Used engine oil is hazardous to health and environment and must in accordance with the law not be poured out on the ground or in the nature, and must be handed in to a workshop or other designated station for treatment. Avoid skin contact, wash with soap and water in the event of spillage.
English – 31
