Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 11 Bio/13 H Bio manual Dismantling of the machine hoods, Engine hood, Maintenance

Models: 11 Bio/13 H Bio

1 43

Download 43 pages 52.23 Kb

Page 19

Image 19

MAINTENANCE

Dismantling of the machine hoods

Engine hood

The engine is accessible for servicing when the engine hood is lifted up.

Tilt the seat forward, release the rubber strap under the seat, and tilt the hood backwards.

Front hood Rider 11 and Rider 13 H

Release the screws in the front hood (3) and lift off the hood.

Front hood Rider 11 Bio and Rider 13 H Bio

Release the catch and lift off the hood.

18 – English

Page 19

Image 19

Husqvarna 11 Bio/13 H Bio Dismantling of the machine hoods, Engine hood, Front hood Rider 11 and Rider 13 H, Maintenance

Contents

Rider 11/13 H Rider 11 Bio/13 H Bio 101Operator´s manual Travel and transport on public roads CONTENTS Operator’s Manual for Rider 11 and Rider 13 HRider 11 Bio and Rider 13 H Bio IMPORTANT INFORMATIONEXPLANATION OF SYMBOLS Clear the area from stones etc. before cutting SAFETY INSTRUCTIONSGeneral use Read the instructions before starting the machineCut slopes upwards and downwards, not sideways Be extra careful when driving on slopesDriving on slopes Do as followsNever allow children to drive the machine MaintenanceChildren Keep children away from the mowing areabefore starting the engine. If fuel is spilt on clothes, change them Clean the machine regularly from grass, leaves and other wasteSAFETY INSTRUCTIONS battery can explode and cause severe injuriesPresentation PRESENTATIONLocation of the controls Brake pedal / Parking brake PRESENTATION RIDER 11 / 11 BIOThrottle and Choke lever Clutch pedalThrottle and Choke lever PRESENTATION RIDER 13 H / 13 H BIOSpeed limiter Parking brakeLifting of the cutting unit transport position Cutting unitLift lever for cutting unit Rider 11 Bio and Rider 13 H Bio have a twin-bladeRider 13 H Lever for adjustment of cutting heightSeat FuellingRider 13 H DRIVINGBefore starting Starting the engine5. Set the throttle control midway between position 1 and Cold engineWarm engine DRIVINGThe clutch must be used for each gear change Driving the machine2. For Rider 13 H and Rider 13 H Bio For Rider 11 and Rider 11 BioIMPORTANT INFORMATION Cutting tipsMowing pattern DRIVINGDRIVING Hill start, manual gearboxStopping the engine Release lever Rider 13 H and Rider 13 H BioMaintenance MAINTENANCEMaintenance schedule Maintenance intervalFront hood Rider 11 Bio and Rider 13 H Bio Dismantling of the machine hoodsEngine hood Front hood Rider 11 and Rider 13 HRelease the screws in the fender and lift off the fender Right-hand fenderLeft-hand fender MAINTENANCEMAINTENANCE Check the engine’s oil levelCheck the engine’s cooling air intake Checking of the fuel pump’s air filterMAINTENANCE Checking and adjustment of the steering wiresChecking the brake Rider 11 and Rider 11 Bio Adjusting the brake Rider 11 and Rider 11 BioCheck and adjust the brakes on Rider 13 H and Rider 13 H Bio Poorly adjusted brakes can result in reduced braking powerCheck the transmission’s oil level Rider 13 H and Rider 13 H Bio Check the level of the battery acidCheck the safety system Procedures on contact with acidIMPORTANT INFORMATION Do not use compressed air to clean the paper filterReplacing the air filter MAINTENANCEMAINTENANCE Checking the cutting unit’s parallelismMAINTENANCE Adjustment of the cutting unit’s parallelismService position for BioClip MAINTENANCE RIDER 11/11 BIOPlacing in service position 5. Disengage the spring from the drive belt tensioning wheel MAINTENANCE RIDER 11/11 BIOTake care not to get your hand trapped Restoring from service positionMAINTENANCE RIDER 11/11 BIO 7. Lift off the drive belt 1. Then pull out the pinMAINTENANCE Checking the bladesChecking the tyre pressure Cutting unit rear ejection BioCheck that the lock-ring is correctly posi- tioned in the slot Changing the oilLubrication Rider 11 and Rider 11 Bio Lubrication of front wheel bearings32 - English Lubrication of belt tensionerGeneral lubrication MAINTENANCEReplacement of the fuel filter Checking and adjustment of the throttle wireMAINTENANCE Problem TROUBLE SHOOTING SCHEDULEProcedure STORAGE ServiceWinter storage Rider 13 H TECHNICAL DATADimensions RiderDimensions Rider 11 BioRider 13 H Bio TECHNICAL DATADirective 89/392/EEC, Annex II, A EU declaration of conformity Only applies to EuropeSvenska ´*3,¶6X¨ Svenska ´*3,¶6X¨ 2000W37