Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 11 Bio/13 H Bio manual MAINTENANCE RIDER 11/11 BIO

Models: 11 Bio/13 H Bio

1 43

Download 43 pages 52.23 Kb

Page 29

Image 29

5.Disengage the spring from the drive belt tensioning wheel.

MAINTENANCE RIDER 11/11 BIO

4.Fit the support wheels on either side of the rear of the cutting unit.

5.Disengage the spring from the drive belt tensioning wheel.

6.Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut. Engage the strut in the holder.

28 – English

Page 29

Image 29

Husqvarna 11 Bio/13 H Bio manual MAINTENANCE RIDER 11/11 BIO, Disengage the spring from the drive belt tensioning wheel

Contents

Operator´s manual 101Rider 11/13 H Rider 11 Bio/13 H Bio Rider 11 Bio and Rider 13 H Bio CONTENTS Operator’s Manual for Rider 11 and Rider 13 HIMPORTANT INFORMATION Travel and transport on public roadsEXPLANATION OF SYMBOLS General use SAFETY INSTRUCTIONSRead the instructions before starting the machine Clear the area from stones etc. before cuttingDriving on slopes Be extra careful when driving on slopesDo as follows Cut slopes upwards and downwards, not sidewaysChildren MaintenanceKeep children away from the mowing area Never allow children to drive the machineSAFETY INSTRUCTIONS Clean the machine regularly from grass, leaves and other wastebattery can explode and cause severe injuries before starting the engine. If fuel is spilt on clothes, change themLocation of the controls PRESENTATIONPresentation Throttle and Choke lever PRESENTATION RIDER 11 / 11 BIOClutch pedal Brake pedal / Parking brakeSpeed limiter PRESENTATION RIDER 13 H / 13 H BIOParking brake Throttle and Choke leverLift lever for cutting unit Cutting unitRider 11 Bio and Rider 13 H Bio have a twin-blade Lifting of the cutting unit transport positionSeat Lever for adjustment of cutting heightFuelling Rider 13 HBefore starting DRIVINGStarting the engine Rider 13 HWarm engine Cold engineDRIVING 5. Set the throttle control midway between position 1 and2. For Rider 13 H and Rider 13 H Bio Driving the machineFor Rider 11 and Rider 11 Bio The clutch must be used for each gear changeMowing pattern Cutting tipsDRIVING IMPORTANT INFORMATIONStopping the engine Hill start, manual gearboxRelease lever Rider 13 H and Rider 13 H Bio DRIVINGMaintenance schedule MAINTENANCEMaintenance interval MaintenanceEngine hood Dismantling of the machine hoodsFront hood Rider 11 and Rider 13 H Front hood Rider 11 Bio and Rider 13 H BioLeft-hand fender Right-hand fenderMAINTENANCE Release the screws in the fender and lift off the fenderCheck the engine’s cooling air intake Check the engine’s oil levelChecking of the fuel pump’s air filter MAINTENANCEMAINTENANCE Checking and adjustment of the steering wiresCheck and adjust the brakes on Rider 13 H and Rider 13 H Bio Adjusting the brake Rider 11 and Rider 11 BioPoorly adjusted brakes can result in reduced braking power Checking the brake Rider 11 and Rider 11 BioCheck the safety system Check the level of the battery acidProcedures on contact with acid Check the transmission’s oil level Rider 13 H and Rider 13 H BioReplacing the air filter Do not use compressed air to clean the paper filterMAINTENANCE IMPORTANT INFORMATIONMAINTENANCE Checking the cutting unit’s parallelismMAINTENANCE Adjustment of the cutting unit’s parallelismPlacing in service position MAINTENANCE RIDER 11/11 BIOService position for BioClip 5. Disengage the spring from the drive belt tensioning wheel MAINTENANCE RIDER 11/11 BIOMAINTENANCE RIDER 11/11 BIO Restoring from service position7. Lift off the drive belt 1. Then pull out the pin Take care not to get your hand trappedChecking the tyre pressure Checking the bladesCutting unit rear ejection Bio MAINTENANCELubrication Rider 11 and Rider 11 Bio Changing the oilLubrication of front wheel bearings Check that the lock-ring is correctly posi- tioned in the slotGeneral lubrication Lubrication of belt tensionerMAINTENANCE 32 - EnglishMAINTENANCE Checking and adjustment of the throttle wireReplacement of the fuel filter Procedure TROUBLE SHOOTING SCHEDULEProblem Winter storage ServiceSTORAGE Dimensions TECHNICAL DATARider Rider 13 HRider 13 H Bio Rider 11 BioTECHNICAL DATA DimensionsDirective 89/392/EEC, Annex II, A EU declaration of conformity Only applies to EuropeSvenska ´*3,¶6X¨ Svenska ´*3,¶6X¨ 2000W37