Husqvarna 966451906 manual Replacing a broken return spring, Starter assembly

Repair Instructions

7.4 Replacing a broken return spring

WARNING!

Exercise care to ensure the spring does not fly out and cause person- al injury. Wear protective goggles.

1

Loosen the screw at the centre of the starter pulley and loosen the screws on the cassette. Remove the starter pulley with the cassette and spring.

2

Remove the broken cassette and replace it with a new one.

3

Tighten the screw at the centre of the starter pulley, at a tightening torque of 2-3 Nm. Load the return spring, see “Loading the return spring”. See also the “Dismantling the starter” chapter.

7.5 Starter assembly

1

Position the starter against the crankcase and tighten the screws at a tightening torque of 3-4 Nm.

English - 27