Repair Instructions
2
Make sure the cabling is fitted to its mounting on the intake flange.
Press the fuel hose (D) in place in the collar on the intake bellows.
Hook on the throttle cable (E) in its mounting on the intake bellows. See figure 46.
Make sure the lug on the carburettor hooks in place on its mounting on the intake system.
Make sure that the following components are correctly fitted:
•Position the air filter holder against the carburettor.
•Make sure the carburettor cover’s intake channel is aligned correctly with the slot for the air filter holder.
•The spring must be fitted under the choke pin on the carburettor. See figure 47.
•The rubber collar on the stop button must be on the inside of the bottom of the carburettor com- partment. See figure 47.
•NOTE! Make sure that the fuel and return hoses are not crushed.
3
Position the guide taps on the air filter holder in the rubber grommets, G. See figure 48.
D |
E |
Fig 46 |
Fig 47
4
Hook on the throttle cable, E. See figure 46. Fasten the return hose B and secure it in its mount- ings on the air filter holder.
Attach the pressure hose A, with the short hose on the short plastic plug on the fuel pump.
Attach the tank bleeding hose, C. See figure 49.
5
Hook it on the left side and then the right side of the carburettor in the rubber mounting. Then screw the carburettor in place. See figure 48.
6
Fit the air filter.
Fig 48
Fig 49
