Repair Instructions
7.11 Assembling the oil pump and screen
1
Lower the oil filter in place and replace the oil pump as outlined in figure 19 and tighten the screws.
2
Fit the pump drive wheel, the needle bearing, the drive sprocket, the clutch drum and the clutch, us- ing a tightening torque of 25 Nm.
3
Adjust the oil pump. See Figure 21.
4
Fit the clutch. See the “Assembling the centrifugal clutch” chapter.
5
Fit the chain, bar and clutch cover.
Fig 21
WARNING!
Insufficient chain lubrication can result in chain breakage, which can cause serious personal injury.
7.12 Dismantling the intake system
The intake system consists of:
• The inlet manifold, A
• The partition wall, B
• The intake flange, C See Figure 22.
1
Dismantle the cylinder cover.
Fig 22 |
2
Loosen screws D and the movement limiter E as outlined in figure 23. Loosen the ignition cable.
D |
D |
D D |
E |
Fig 23 |
32 - English
