
Repair Instructions
7.6Dismantling the ignition module and flywheel
1
Remove the cylinder cover. Remove the starter. Snap off the ignition cable from the guide rail and remove the guide rail. See figure 7.
Fig 7
2
Knock out a few of the pins in the tool if it does not match up with the flywheel.
Use the tool to hold the flywheel in place while the flywheel nut is loosened using a suitable socket wrench. See figure 8.
Fig 8
4
Thread the mandrel on the crank pin. Screw in until
Unscrew the air nozzle to replace the ignition mod- ule. Loosen the screws on the ignition module. See figure 10.
Dismantle the air filter, air filter holder and carburet- tor. See the “Dismantling the carburettor” chapter.
Dismantle the tank unit as outlined in the “Disman- tling the tank unit” chapter.
Dismantle the intake system, see the “Dismantling the intake system” chapter.
Loosen the earth cable. See figure 11. Pull the cables through the openings in the crankcase.
Cleaning and inspection
• Clean all parts, especially the tapers on the flywheel and shafts.
• Check the flywheel for cracks or any other signs of damage.
28 - English
Fig 9
Fig 10