Repair Instructions
Assembly
1. Thread the throttle cables in the connection M as outlined in figure 55. NOTE! The figure is shown from underneath.
2. Run the fuel hose D through hole K and hoses B and C in hole L. See figure 55. Pull the hoses so that the collars are on each side of the bot- tom on the carburettor compartment.
3. Tighten the chain catcher in place.
4. Press the movement limiter H into position. See figure 53.
5. Tighten the screws F. See figure 51.
6. Hook on the throttle cable E in the intake bellow. See figure 50.
7. Fit the tank unit. The two short screws are fitted to the bottom of the handle bar.
8. Assemble the carburettor as outlined in “Assem- bling the carburettor”. Assemble the air filter and cylinder cover.
7.17 Vibration damping system
Dismantling
1. Dismantle the following parts:
•Bar and chain. See the Operator’s Manual.
•Cylinder cover. See the Operator’s Manual.
•Tank unit and handle. See “Dismantling the tank unit”.
2. Dismantle the spring on the handle bar using a 4 mm Allen key (see figure 57).
3. Dismantle the springs on the tank unit using a 4 mm Allen key (tool 502 50
Cleaning and inspection
Clean and inspect all parts.
Assembly
1. Fit the springs on the handle bar using a 4 mm Allen key (tool 502 50
2. Assemble the following parts:
•Tank unit and handle. See “Assembling the tank unit”.
•Cylinder cover. See the Operator’s Manual.
•Bar and chain. See the Operator’s Manual.
Fig 54 |
Fig 55
Fig 56
Fig 57 |
English - 43 |
