Husqvarna CG 200 S manuel dutilisation Starting up, Working procedure, Belt tensioning

•PETROL VERSION. Consult the engine maintenance manual.

Take into account the working conditions from health and safety point of wiew.

-Check fuel and oil level.

-To start the engine, refer to the engine operating instructions and paragraph 7 "Starting up".

•ELECTRIC VERSION. Check the following:

		ELECTRICAL SAFETY :
		Operate this machine only on a supply
		equipped with a 30 mA earthed current-
		limiting circuit-breaker. Otherwise,
English		consult our catalogue for appropriate
		models.
	- Check the mains voltage (SINGLE PHASE, 230
		V - THREE PHASE 400 V).
	-	Check that the motor is connected to electric
		cable with conductors of 4 mm2 section (single
		phase) and 2.5 mm2 (three phase) for lengths
		less than 100 m. Above this length, double the
		section.
	-	THREE PHASE : Check that the motor is
		turning in the same direction as that of the
		arrow located on rear cover of the motor (if not,
		reverse 2 of the wires).

- To start the motor, refer to paragraph 7 "Starting up".

22

7 Starting up

Always take care.

Get into a comfortable, balanced position.

Remove all adjustment tools and wrenches from floor and machine

To start the planer, grasp the dead man’s handle (I) on the steering shaft. The motor stops if this is released. As a safety precaution, check regularly that it operates correctly. Do not lock it in position.

•PETROL VERSION:

-Refer to the manufacturers manual.

-Let the engine warm up.

•ELECTRIC VERSION:

-The planer is operated by the on/off switch (emergency stop using the handle (I)).

•DUST EXTRACTOR:

-Fit the suction (U) hose directly onto connector located on the back of the machine (health and safety) [SEE FIG. 5].

8 Working procedure

•To mill concrete, pass the machine over several times according to the nature of concrete and until desired result is obtained.

•Millimetric depth adjustment [SEE FIG. 6] :

-Action the fly-wheel (C) that will act on the screw (D).

-Turn the nut (E) to lock the screw and secure the cutting depth.

•Quick release:

-Pull lever (B) backwards to release the drum quickly.

-And push forwards at the preselected depth to resume work.

9 Belt tensioning

•Check periodically belt tension and retighten it when necessary but do not overtighten, by means of the nut (S) and lock nut (T) [SEE FIG.x7].

Never set belts beyond original tension