Removal and Replacement Procedures |
|
Fiscal interface card
1.Remove the fiscal interface assembly from the printer (see ªFiscal interface assemblyº on page 6).
2.Remove the fiscal processor card (see ªFiscal processor cardº on page 11).
3.Unscrew the four standoffs from the fiscal interface assembly.
Attention: Use a hex nut driver to unscrew the four standoff screws to avoid bending the nearby connector pins on the interface card.
4.On the vertical part of the base of the fiscal interface assembly, remove the two hex nuts, two lock washers, and two flat washers from the RS±232 port connector.
5.Tilt and pull the interface card upwards until it is free from the fiscal printer card assembly.
Figure 10. Removing Fiscal Interface Card from Housing
144610 - Kxx Fiscal Printer Service Supplement
