Notes:
1. The BIOS and VitalProduct Data (VPD) for the computer you are servicing must be
installed on the new system board (FRU) after it is installed in the computer.To do
this, you must run the Flash Update program using the Flash Update diskette. See
“BIOS levels”on page 199, “Vital productdata”on page 198, and “Flash (BIOS/VPD)
update procedure”on page 200.
2. Always ensure the latest level of BIOS is installed on the computer.A down level BIOS
may cause false errors and unnecessary replacement of the system board.
3. The processor is a separate FRU from the system boardand is not included with the
system board FRU.
4. If the new system board does not correct the problem, reinstallthe options on the old
system board, reinstall the old system board, then replacethe processor.
1. Remove the cover. See “Removing the cover - desktop model”on page 34.
2. Remove the 7 screws that attach the system board to the chassis.
3. Remove the board from the chassis.
4. Remove the processor from the old system board and install it on the new
system board.
5. Remove any of the following installed options on the old system board, and
install them on the new system board.
vMemory modules
6. Ensure that the new system board jumper settings match the old system board
jumper settings.
Replacing a processor - Desktop Model
Attention: When you handle ESD-sensitive devices, take precautions to avoid
damage from static electricity.For details on handling these devices, see “Handling
electrostatic discharge-sensitive devices”on page 210.
1. Review the safety precautions listed in “Safety information”on page 207.
Chapter5. FRU Replacements 63