If NO, continue to 002.
If YES, proceed to 003.
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see “Setup Utility program”on
page 8)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow(})or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003.
003
Run diagnostics. If necessary,refer to “Diagnostics”on page 10.
vIf you receive an error,replace the part that diagnostics calls out or go to
″Symptom-to-FRU Index″on page 39.
vIf the test stops and you cannot continue, replace the last device tested.
2HardwareMaintenance Manual