vDestroys all copies of the FATTable on all partitions (both the master and
backup).
vDestroys the partition table.
vProvides messages that warn the user that this is a non-recoverable process.
The Full Erase Hard Drive provides a DOS utility that performs the following
steps.
vPerforms all the steps in Quick Erase.
vProvides a DOS utility that writes random data to all sectors of the hard drive.
vProvide an estimate of time to completion along with a visual representation of
completion status.
vProvides messages that warn the user about non-recoverable process.
Important: Make sure that all data is backed up before using the Quick or Full Erase
functions.
Toselect the Quick Erase or Full Erase Hard Drive utility, use the following
procedure.
1. Select the UTILITY option on the toolbar and press Enter.
2. Select either the QUICK ERASE or FULL ERASE HARD DISK option and
follow the instructions.
Iomega Zip drive test
Use the Iomega Zip Drive Testto test the Zip drive and the drive interface. The
test takes about 20 seconds to run.
The default tests the following:
vController
vMax Seek (50 times)
vRandom Seek (300 sectors)
Asset EEPROM backup
When replacing a system board, this utility allows the backup of all Asset
information from the EEPROM to diskette. This utility also restores data to the
EEPROM from diskette after replacement of the system board.
Torun this utility, use the following procedure.
vSelect Utility
vSelect Asset EEPROM Backup
vFollow instructions on screen.
Viewing the test log
Errors reported by the diagnostic test will be displayed by the program as a failed
test.
Toview details of a failure or to view a list of test results, use the following
procedure from any test category screen.
vPress F3 to activate the log file.
vPress F3 again to save the file to diskette or F2 to print the file.
14 HardwareMaintenance Manual