IBM 6826, 8317, 8318, 8319 manual 4

If NO, continue to 002.
If YES, proceed to 003.
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see “IBM Setup Utility
program”on page9)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow(})or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003.
003
Run the Diagnostic programs. If necessary,refer to “Diagnostics” on page 12.
vIf you receive an error,replace the part that the diagnostic program calls out or
go to ″Symptom-to-FRU Index″on page 37.
vIf the test stops and you cannot continue, replace the last device tested.
4HardwareMaintenance Manual