Chapter 4. Diagnostics
The following tools are available to help identify and resolve hardware-related
problems.
vSetup Utility program
vPower-On Self-Test(POST)
– POST Beep Codes
– Error Code Format
vDiagnostics program
vRecovery utility
– Factory Contents
– Partial recovery
vRepair utility

IBM Setup Utility program

The IBM Setup Utility program is stored in the electrically erasable programmable
read-only memory (EEPROM) of your computer.The IBM Setup Utility program is
used to view and change the configuration settings of your computer, regardlessof
which operating system you are using. However,the operating-system settings
might override any similar settings in the IBM Setup Utility program.
Tostart the IBM Setup Utility program, do the following:
1. If the computer is already on when you start this procedure, shut down the
operating system and turn off the computer.
2. Turnon the computer and look for the following prompt on the logo screen:
(To interrupt normal startup, press Enter)
Press Enter when you see the prompt. The Startup Interrupt Menu is displayed.
3. Press F1 to start the IBM Setup Utility.
Note: If a user password is set, you must type the password to continue. If an
administrator password has been set, you cannot make any changes to
configuration using the IBM Setup Utility program until you type your
administrator password. See “Passwords”on page 103 for more
information.
The IBM Setup Utility might start automatically when POST detects that hardware
has been removed or new hardware has been installed in your computer.A sample
© Copyright IBM Corp. 2001 9