IBM manual Quick Installation, Detailed Installation, MegaRAID 8480 Hardware Installation

2.2Quick Installation

The following steps are for quick MegaRAID 8480 Storage Adapter installation. These steps are for experienced computer users/installers. Section 2.3, “Detailed Installation,” contains the steps for all others to follow.

Step 1. Review all safety information provided with the server; then, turn off the server and all attached devices and unplug the server and device power cords.

Step 2. Open the cabinet of the host system by following the instructions in the host system technical documentation.

Step 3. Check the memory module on the adapter.

Step 4. Install the MegaRAID 8480 Storage Adapter in the server and connect SAS or SATA II devices to it. Ensure that the cables you use conform to all specifications.

Step 5. Perform a safety check.

a.Ensure that all cables are properly attached

b.Ensure that the MegaRAID 8480 Storage Adapter is properly installed

c.Close the cabinet of the host system

Step 6. Turn power on after you complete the safety check.

2.3Detailed Installation

This section provides detailed instructions for installing a MegaRAID 8480 Storage Adapter.

Step 1. Unpack the Storage Adapter

Unpack and remove the MegaRAID 8480 Storage Adapter. Inspect it for damage. If it appears damaged, or if any of the following items are missing, contact your place of purchase. The MegaRAID 8480 Storage Adapter is shipped with:

2-2	MegaRAID 8480 Hardware Installation
	Copyright © 2006-2007 by LSI Corporation. All rights reserved.