9.The Console (10) requires four "D" batteries (not included); alkaline batteries are recom-
mended. IMPORTANT: If the elliptical exer- ciser has been exposed to cold tempera- tures, allow it to warm to room tempera- ture before inserting batteries into the Console. If you do not do this, the console displays or other electronic components
may become damaged. Remove the battery cover from the bottom of the Console and
insert four batteries into the battery compart- ment. Make sure the batteries are oriented
as shown by the diagram inside the battery compartment. Then, reattach the battery cover.
Have a second person hold the Console (10) near the Upright (2) as shown. Connect the console wires to the Upper Wire Harness (18) and the Pulse Wire (11). Attach the Console
(10)to the Upright (2) with four M4 x 16mm Round Head Screws (93). Be careful to avoid pinching the wires.
10.Identify the Left Upper Body Arm (4), which is marked with a "Left" sticker. Orient the Left Upper Body Arm so that the indicated tube is facing inward.
Lubricate the upper end of the left Upper Body Leg (6) using a small amount of the included
Apply a generous amount of grease to the Pivot Axle (16). Then, insert the Pivot Axle through the Left Upper Body Arm (4), an Upper Body Arm Spacer (29), and the Upright (2). Make sure the Upper Body Arm Spacer is oriented as shown, with the arrow pointed down.
9
11
93
Console Wires
18
10
29
Grease _.
Lubricate
10
