11. Orient the Right Upper Body Arm (5) so that | 11 | |
the indicated tube is facing inward. Lubricate | ||
| ||
the upper end of the right Upper Body Leg (6) |
| |
with |
| |
the Right Upper Body Arm onto the Upper |
| |
Body Leg. |
| |
Then, slide the Pivot Axle (16) through the |
| |
remaining Upper Body Spacer (29) and the |
| |
Right Upper Body Arm (5). |
|
16\
Lubricate
12. Apply a small amount of grease to a Wave | // | |
Washer (27). Slide an | 12 | |
M8 Large Washer (81) |
| |
and the Wave Washer | onto an M8 x 25mm |
|
Patch Screw (70), and tighten the Patch Screw into the left end of the Pivot Axle (16). Then, press a Pivot Cover (14) against the Left Upper Body Arm (4).
Repeat this step on the right side of the elliptical exerciser.
14
27
Grease
14
13.Make sure that all parts of the elliptical exerciser are properly tightened, Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11
