IMC Networks Giga-AcessEtherLinx-II operation manual DC Power Supply Wiring Instructions

Strongly recommended:

•128 MB RAM

•Pentium III 650Mhz or Faster

•17” Monitor @ 1024 x 768 Resolution or higher

Installing and Using iView²

iView² is available to install as a download at www.imcnetworks.com/Products/iView.cfm.

When using iView² with HP OpenView

During the installation, the iView² application will ask if HP Open View is installed on the management PC. Click Yes to integrate the appropriate files. Once in OpenView, select IMC Networks from the toolbar to view the IMC Networks devices.

When Not Using iView²

When using an application other than iView² for management, integrate the SNMP vendor files (a.k.a. MIBs) into the application. The SNMP agent uses the following Enterprise-specific MIB file and standard MIBs, which can be found in the MIB directory within the iView² download files.

Using the IMC MIBs

Refer to the MIBs folder located with the iView² software for product-related MIBs.

DC Power Supply Wiring Instructions

DC Power Supply	DC Power Supply
If in a -48 environment:	If in a +48 environment:

GND			-48	+48		GND
(Common)		Chassis			Chassis	(Common)
		Gnd			Gnd
	Terminal Block				Terminal Block

NOTE

Incorrect wiring will result in chassis malfunction. The Giga-AccessEtherLinX-II (DC) is compliant with Isolated Grounding Plane practices. The POSITIVE and NEGATIVE terminals are isolated from chassis ground and must have a ground reference at the power-sourcing equipment.

31