Adjusting the angle of projection
Screen on a flat wall with a 90 degree angle to the floor by adjusting two foot adjustments on the bottom of the projector. If the angle cannot be corrected by them, adjust the height and angle of screen.
Getting ready for projection
1.Connect the power cord provided to this projector with the power jack of the projector.
2.Connect the power cord to the wall outlet.
3.Take off the lens cap.
4.Do not look directly into the lens when projector is “ON”.
Warning:
ENGLISH
screen
foot adjustment
• | The lens cap is for protecting the lens. If you leave the |
| power on with the cap on, the cap may be warped. Please |
| remove the lens cap when you turn the power on. |
• | Use the appropriate power cord for your country. |
1.Lift the projector to the right angle.
2.Press the release button for angle adjustment to take the adjustment feet out of the projector.
3.Release the button and keep your hands away from the projector.
4.Turn the both feet to right or left to adjust for proper angle.
After using the projector
5.Press the release button to take the projector down slowly while holding it.
Important:
The image becomes trapezoid shape when the screen or projector is not level. Use KEYSTONE in INSTAL- LATION menu to adjust, however, the circumference of the image may not be focused. See page 20.
•Screen on a flat wall with a 90˚ angle to the floor.
•Align projector to produce a full screen display as illustrated on page 10.
•Distance from projector to screen must be compatible with screen size chart on page 10. Note distance from screen chart.
•If image is not square on screen, try adjusting the front feet of the projector for proper angle.
• A |
the projector. Do not remove the grounding pin on |
the power plug. If you are unable to insert the plug |
into the outlet, contact your electrician to replace |
your obsolete outlet. |
• Use |
otherwise it may lead to fire or electric shock. |
• Do not place an object on the power cord and keep |
the projector away from heat source to avoid break- |
ing the power cord. A broken of power cord can cause |
fire or electric shock. |
• Do not revise or alter the power cord otherwise it |
may cause fire or electric shock. |
Contact your dealer if the cord is broken. |
Caution:
•Plug in firmly and unplug by holding the plug, not by pulling the cable out.
•Do not plug in or out with wet hands. It may cause an electric shock.
11
