AUTO POSITION button
When the source is selected to RGB1 or RGB2 and the image is not in the right place, set to display as blightest signal as possible, then press the AUTO POSITION button. If the image is still not in the right place.
•Set screen to the brightest display possible (e.g.,
•If the screen saver is running, turn off the screen saver before using the automatic adjustment button.
5.Press the FOCUS/ZOOM button to FOCUS. “FO- CUS” will appear on the display.
6.Adjust with the ª or º buttons on the control panel (or { or } buttons on the remote control) to get a fine picture.
•Focus and zoom adjustment by using the buttons on the control panel or the remote control is possible in the normal picture mode only. In PinP, EXPAND or cursor operation mode, the adjustment is impossible.
The volume from the speaker
Press the VOLUME buttons on the remote control to change the volume from the speaker. You can also change it by selecting the volume in AUDIO menu. When setting “ON” for MUTE in AUDIO menu, you can stop the sound momentary.
•The volume button does not work when MENU se- lecting bar or MENU is displayed.
Turning off the projector
7.Press the POWER button.
The message “POWER OFF? YES : PRESS AGAIN” appears on the screen.
•To exit from this mode, press any button except POWER button.
8.Press the POWER button again.
The light source lamp will be turned off.
By pressing the POWER button again, shuts off the light source lamp, but the exhaust fan continues to operate for 120 seconds to cool down the light source lamp and LCD panels. In this time, the lamp indica- tor will be turned off from flashing.
9.Turn off the main power switch. When turning off the main switch, the POWER indicator turns off.
•In cases where the main power switch is acciden- tally turned off when either the intake/exhaust fan or the power source lamp is in operation, allow the unit to cool down for 10 minutes with the power turned off. Repeat step 3 when turning on the power source lamp. If the lamp does not turn on immediately, repeat this step two or three times. Replace the lamp if it should still fail to turn on.
Caution:
•When you have finished using this equipment, wait 120 seconds for the exhaust fans to stop. Then turn off the main switch and unplug the power cable from the wall outlet, for safety purposes.
•After the lamp is turned off, the lamp cannot be switched on again for 60 seconds as a precaution- ary measure. It will take another 60 seconds before the lamp indicator goes off. If you wish to turn on the projector again, wait until the indicator is off then press the POWER button.
•The exhaust fans faster automatically when the tem- perature around the projector becomes high.
•When the temperature around the projector becomes much higher, the sign of “TEMP!!” blinks red on the screen. If the temperature stays in high, the lamp will be shut off automatically .
The projector automatically shuts off when the lamp is used up in about 1,300 hours and not used until lamp replacement.
ENGLISH
17
