InFocus VR 9DM2 manual Battery REMOVAL/INSTALLATION, Application, Charging

English

7.Bit adaptor: Code No. 322752 (WR12DM2)

This is used for tightening small screws (M6 – M8).

NOTE:

(1)This adaptor is set only on the anvil (drive angle) of the main unit. The bit adapter cannot be attached to the special accessory anvil (square drive).

(2)Before starting work with the adapter, tighten a few screws with it to make sure it’s tightening with the appropriate torque.

(3)Tightening speed will be greatly reduced when driving wood, tapping or other similar screws.

BATTERY REMOVAL/INSTALLATION

1.Battery removal

Hold the handle tightly and push the battery latch to

remove the battery. (See Fig. 1 and 2)

CAUTION:

Never short-circuit the battery.

2.Battery installation

Insert the battery while observing its polarities. (See Fig. 2)

Optional accessories are subject to change without notice.

APPLICATION

< WH12DM2, WH9DM2, WH12DMR >

◯Driving and removing of small screws, small bolts, etc.

< WR12DM2, WR9DM2 >

◯Tightening and loosening of all types of bolts and nuts, used for securing structural items

Table 5

CHARGING

Before using the impact driver, charge the battery as follows.

1.Connect the charger’s power cord to a receptacle. When the power cord is connected, the charger’s pilot lamp will blink in red. (At 1-second intervals.)

2.Insert the battery into the charger.

Insert the battery firmly, in the direction shown in Fig. 3, until it contacts the bottom of the charger

compartment.

CAUTION:

◯If the battery is inserted in the reverse direction, not

only recharging will become impossible, but it may also cause problems in the charger such as deformed recharging terminal.

3.Charging

When inserting a battery in the charger, charging will commence and the pilot lamp will light up continuously in red.

When the battery becomes fully recharged, the pilot lamp will blink in red. (At 1-second intervals.) (See

Table 5)

(1)Pilot lamp indication

The indications of the pilot lamp will be as shown in Table 5, according to the condition of the charger or the rechargeable battery.

Indications of the lamps

Before charging

While charging

Charging complete

Charging impossible

Charging impossible

Blinks	Lights for 0.5 seconds. Does not light for
(RED)	0.5 seconds. (off for 0.5 seconds)
Lights	Lights continuously
(RED)
Blinks	Lights for 0.5 seconds. Does not light for
(RED)	0.5 seconds. (off for 0.5 seconds)
Flikers	Lights for 0.1 seconds. Does not light for
(RED)	0.1 seconds. (off for 0.1 seconds)
Lights
	Lights continuously
(GREEN)

Malfunction in the battery or the charger

The battery temperature

is high, making recharging impossible.

11