Integra DPS-7.3 AC Inlet and then into, Power outlet on the wall, Press Standby/On on the DVD

Setting Up the Player

Connecting the Power/Turning on the DVD Player

Before connecting

•The DPS-7.3 is shipped with the main power (Power) switch in the on position (_ On). When the power cord is plugged in for the first time, the DPS-7.3 will automatically enter the standby state and the Standby indicator will light (same condition after step 2 below).

•Make sure that all the connections on pages 13-15 are complete (the connection to a TV is required).

1	Plug the supplied power cord into
	the AC INLET and then into the

power outlet on the wall.

• Do not use a power cord other than the one supplied with the DPS-7.3. The power cord supplied is designed for use with the DPS-7.3 and should not be used with any other device.

• Never have the power cord disconnected from the DPS-7.3 while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and disconnect by unplugging from the wall outlet first.

AC INLET

To the mains

2 Power

Press Power to switch on the main power.

The DVD Player enters standby mode.

The Standby indicator lights up.

•The buttons on the remote controller do not operate if the Power switch is set to Off.

•To switch off the main power, press Power again.

3	Standby/On	Press Standby/On on the DVD
		Player or ON on the remote

controller.

The DVD Player turns on and the Standby indicator turns off.

•To put the DVD Player in the standby mode, press Standby/On on the DVD Player, or STANDBY on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the standby mode for the next use to avoid sudden loud sound reproduction.

•While the Standby indicator lights up, the DVD Player can receive signals from the remote controller. However, if you press Power on the DVD Player to switch off the main power, the remote controller cannot be used to turn on the DVD Player.

•Setting the Standby button to standby does not shut off the power completely.

16