Intel 550T manual Awaiting Drawing from EBZ

C H A P T E R 1 Intel Express 550T Routing Switch

In an equipment rack

Ambient temperature

•Customer-supplied screws for securing the switch in the rack.

Mounting screws are not provided because the required sizes may vary from rack to rack.

To mount the switch in a standard equipment rack:

1Attach the mounting bracket marked “Left” to the left-hand side of the switch, and attach the mounting bracket marked “Right” to the right-hand side of the switch, using the four screws pro- vided.

					Slot B		LEDs Green Orange
	Slot A						Off	10 Mbps Half duplex Intel Express
							Solid	100 Mbps Full duplex	550T Routing
								Port Status	Switch
									Status	Power
							LEDs Green Orange		Temperature	Reset
							Solid	Link Disabled	RPS
							Blink	Activity Collision
971126 Awaiting Drawing from EBZ										Console
1	2	3	4	5	6	7	8
										9600-8-N-1
										1679

Make sure that you attach the mounting brackets to the correct sides. Otherwise the switch will not align correctly in the equipment rack.

2If the four rubber feet prevent the switch from standing firmly on the equipment rack’s side support rails, remove them.

3Set the switch in the equipment rack, and make sure there is adequate space for air flow around the switch (see “Allow ade- quate ventilation” in “Positioning and Installing the Switch”, p. 7).

4Screw the mounting brackets securely to the equipment rack.

If the switch is installed in a closed or multi-rack assembly, the oper- ating ambient temperature of the rack environment may be greater than the ambient temperature of the room. Make sure that the temper- ature of the rack environment does not exceed the recommended op- erating temperature for the switch.

8