Intel 550T manual Start-up, They are operating correctly, LEDs reflect the state of each port

CH A P T E R 1 Intel Express 550T Routing Switch

Power up

Powering up the switch Follow these steps to power up the switch:

1Push the female end of the power cable into the main socket (in the rear panel); plug the other end into the power supply outlet.

2Make sure that the Power LED (on the front panel) is green.

If it isn’t green, make sure that the power outlet is working cor- rectly (switched on). If the power outlet is on and the Power LED is not green, then there is a fault within the switch and you must contact your dealer.

3Verify that an LED is lit for each of the front panel ports where a powered on device is connected.

Start-up procedure	Immediately after power-up, the following should happen during
	start-up:
	Stage	STATUS LED...	Then the switch...
	1	Is red	Is starting up
	2	Turns to steady green	Has started successfully
	If the Status LED remains red, then the switch has not started success-
	fully. Try to restart it; if the switch does not start, contact your dealer.
	Look at the other front panel LEDs during start-up and check that
	they are operating correctly.
Port LED states	The LEDs reflect the state of each port:

LED	Indicates
No lights	Port enabled, no link.
Green, blinking	Port enabled, Rx/Tx traffic, link pulse
randomly	active.
Green, solid	Port enabled, link pulse active.

13