Intel 550T manual Changing the Setup Port

C H A P T E R 3 Standard Configuration

Changing the forward	To change the time between port states while the bridge attempts to
delay expiry time	become the root:
	1	Select Device Setup or Stack Setup.
	2	Click Spanning Tree.
	3	Click Forward Delay Timer Expiry.
	4	Type the required number of seconds.
	5	Click OK.

Changing the state of the ports

To specify that all ports are using Spanning Tree Protocol:

1Select Device Setup or Stack Setup.

2Click Spanning Tree.

3Click Enable All Ports.

The ports are able to resolve problematic network loops using STP.

4Click OK.

Changing the Setup of the

Port

Purpose	You can configure the port to operate in different ways, according to
	your network’s requirements:
	•	Change the port state
	•	Select the auto-negotiation mode
	•	Change each port to half or full duplex
		(If auto-negotiation is not enabled)
	•	Specify the speed of the port
		(If auto-negotiation is not enabled)
	•	Change the forwarding mode of the port
	•	Change the flow control setting of the port
	•	Specify the spanning tree

57