Specifications, Main CPU Board | Intel FPC 5084, N270 manual

FPC 5084

CompactFlash™ card, which makes it suitable for vibration environments.

Embedded O.S. Supported

The FPC 5084 not only supports Windows® XP, but also supports embedded OS, such as Windows® CE.NET, and Windows® XP embedded. For storage device, the FPC 5084 830 supports CompactFlash™ card.

Industrial-grade Product Design

The FPC 5084 has an incredible design to be used in different industrial environments.

The front bezel meets the IP65/NEMA4 standard.

For connecting other devices, the FPC 5084 also features several interfaces: USB, Ethernet, and RS-232/422/485.

1.2Specifications

1.2.1 Main CPU Board

CPU

Intel○R AtomTM N270 1.6GHz processor with FSB 533MHz onboard

System Chipset

945GSE + ICH7M

BIOS

America Megatrends BIOS

System Memory

One 200-pin DDR2 SO-DIMM socket

Maximum memory up to 2GB

2	Introduction

Image 10

Intel FPC 5084, N270 user manual Specifications, Main CPU Board

Contents

FPC Disclaimers Safety Approvals FCC Compliance Safety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable Design Specifications Main CPU Board System Specification 2 I/O System FPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card Installation Hardware Installation Serial Ports Interface Signal Name Pin Signal Ethernet Mountings Panel/Wall/Desktop/VESA Panel Mounting Wall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation Keys Main Menu System Time/Date Advanced Menu Max Cpuid Value Limit Configure advanced CPU settingsExecute-Disable Bit Capability Hyper Threading Technology IDE Configuration Enhanced C-States Serial Port2 Address Serial Port1 AddressSerial Port1 IRQ Serial Port2 IRQ Serial Port4 Address Serial Port4 IRQ Hardware Health Configuration System Temperature/CPU Temperature Acpi Settings Power Management/APM APM ConfigurationVideo Power Down Mode Suspend Time Out Minute Hard Disk Drive Power Down ModePower Button Mode Throttle Slow Clock Ratio Resume On RTC Alarm Advanced Resume Event Controls Resume On Ring MPS Configuration MPS Revision PCI Express Configuration Active State Power-Management SB Pcie Ports Configuration Bios Ehci Hand-Off USB ConfigurationUSB 2.0 Controller Mode Legacy USB Support PCI PnP Menu Plug & Play O/S PCI Latency TimerClear Nvram Allocate IRQ to PCI VGA OffBoard PCI/ISA IDE Card Palette SnoopingPCI IDE BusMaster IRQ3/4/5/7/9/10/11/14/15 Boot Menu AddOn ROM Display Mode Boot Settings Configuration Quick BootQuiet Boot Boot Num-Lock Boot Device Priority Wait For ‘F1’ If ErrorHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Change Supervisor Password Supervisor PasswordUser Password Change User Password Boot Sector Virus Protection Chipset Menu Boot Graphic Adapter Priority North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Internal Graphics Mode Select AMI Bios Setup Utility South Bridge Configuration USB Function Restore on AC Power LossPcie Port Configuration USB 2.0 Controller Discard Changes and Exit Exit MenuSave Changes and Exit Discard Changes Load Optimal Defaults Load Fail-Safe Defaults Chapter Drivers Installation System Driver Installation- Windows XP SpecificationTouch Screen FPC Installation of Drivers Windows XP Embedded Embedded O.SPenMount Touch screen Windows CE.NET Calibration Touch screen