FPC 5084 User Manual
expired. The default setting is Suspend.
Disabled
Suspend
This setting prevents the BIOS from initiating any power saving modes concerned with the video display or monitor.
This option places the monitor into suspend mode after the specified period of display inactivity has expired. This means the monitor is not off. The screen will appear blacked out. The standards do not cite specific power ratings because they vary from monitor to monitor, but this setting use less power than Standby mode. This is the default setting.
Hard Disk Drive Power Down Mode
This option specifies the power conserving state that the hard disk drive enters after the specified period of hard drive inactivity has expired. The default setting is Suspend.
| This setting prevents hard disk drive power | |
| ||
Disabled | ||
down mode. | ||
| ||
| This option cuts the power to the hard disk | |
| ||
|
| |
Suspend | drives during a system suspend. This is the | |
| default setting. |
Suspend Time Out (Minute)
This option specifies the length of time the system waits before it enters suspend mode. The default setting is Disabled.
| This setting prevents the system from entering | |
Disabled | ||
suspend mode. This is the default setting. | ||
| ||
| Set this item to allow the computer system to enter | |
1 Min | ||
suspend mode after being inactive for 1 minute. | ||
| ||
| Set this item to allow the computer system to enter | |
4 Min | ||
suspend mode after being inactive for 4 minutes. | ||
| ||
| Set this item to allow the computer system to enter | |
10 Min | ||
suspend mode after being inactive for 10 minutes. | ||
|
Throttle Slow Clock Ratio
Use this item to specify the speed of the system clock when running the power saving states.
Power Button Mode
This option specifies how the externally mounted power
AMI BIOS Setup Utility | 35 |
