USB Configuration, Legacy USB Support | Intel FPC 5084, N270

FPC 5084

USB Configuration

You can use this screen to select options for the USB Configuration, and change the value of the selected option. A description of the selected item appears on the right side of the screen.

Legacy USB Support

Use this item to enable or disable support for USB device on legacy operating system. The default setting is Enabled.

USB 2.0 Controller Mode

Use this item to configure the USB 2.0 controller. The default setting is HiSpeed.

BIOS EHCI Hand-Off

Enabling this item provide the support for operating systems without an EHCI hand-off feature. The default setting is Enabled.

40	AMI BIOS Setup Utility

Image 50

Intel FPC 5084, N270 user manual USB Configuration, Legacy USB Support, USB 2.0 Controller Mode, Bios Ehci Hand-Off

Contents

FPC Disclaimers Safety Approvals FCC Compliance Safety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable Design Specifications Main CPU Board System Specification 2 I/O System FPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card Installation Hardware Installation Serial Ports Interface Signal Name Pin Signal Ethernet Mountings Panel/Wall/Desktop/VESA Panel Mounting Wall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation Keys Main Menu System Time/Date Advanced Menu Max Cpuid Value Limit Configure advanced CPU settingsExecute-Disable Bit Capability Hyper Threading Technology IDE Configuration Enhanced C-States Serial Port2 Address Serial Port1 AddressSerial Port1 IRQ Serial Port2 IRQ Serial Port4 Address Serial Port4 IRQ Hardware Health Configuration System Temperature/CPU Temperature Acpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Suspend Time Out Minute Hard Disk Drive Power Down ModePower Button Mode Throttle Slow Clock Ratio Resume On RTC Alarm Advanced Resume Event Controls Resume On Ring MPS Configuration MPS Revision PCI Express Configuration Active State Power-Management SB Pcie Ports Configuration Bios Ehci Hand-Off USB ConfigurationUSB 2.0 Controller Mode Legacy USB Support PCI PnP Menu Plug & Play O/S PCI Latency TimerClear Nvram Allocate IRQ to PCI VGA OffBoard PCI/ISA IDE Card Palette SnoopingPCI IDE BusMaster IRQ3/4/5/7/9/10/11/14/15 Boot Menu AddOn ROM Display Mode Boot Settings Configuration Quick BootQuiet Boot Boot Num-Lock Hit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration Change Supervisor Password Supervisor PasswordUser Password Change User Password Boot Sector Virus Protection Chipset Menu Boot Graphic Adapter Priority North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Internal Graphics Mode Select AMI Bios Setup Utility South Bridge Configuration USB Function Restore on AC Power LossPcie Port Configuration USB 2.0 Controller Discard Changes and Exit Exit MenuSave Changes and Exit Discard Changes Load Optimal Defaults Load Fail-Safe Defaults Chapter Drivers Installation System Touch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Windows CE.NET Calibration Touch screen