Installation

IDE1

FDD

34

33

40

39

2

1

2

1

 

FDD

 

 

IDE1

 

 

 

FDD: Floppy Controller Connector

This connects to the floppy disk drive.

IDE1: ATA-66/100 IDE Connector

This mainboard is equipped with 1 IDE connectors to support up to 2 ATA-100 IDE drives.

It supports PIO and DMA mode operations for maximum data transfer rate of 100MB/sec per channel.

When using two IDE drives on the same connector, one must be set to Master mode and the other to Slave mode. Refer to your disk drive user’s manual for details.

PW12

PW1

 

 

 

 

23

24

 

 

 

 

 

3.3V

 

Ground

 

 

 

 

+12V

 

+5V

 

 

 

 

+12V

 

+5V

 

 

 

 

5VSB

 

+5V

3

 

 

4

PW-OK

 

-5V

 

Ground

 

Ground

+12V

 

+12V

 

 

+5V

 

Ground

Ground

 

Ground

Ground

 

Ground

1

2

+5V

 

PS-ON

PW12

Ground

 

Ground

 

 

 

 

3.3V

 

-12V

 

 

 

 

3.3V

 

3.3V

1 11

PW1

PW1: 24-pin ATX Power Connector

PW12: 4-pin ATX12V Power Connector

The mainboard is equipped with a standard 24-pin ATX main power connector and a 4-pin +12V power connector for connecting an ATX12V power supply. The plugs of the power cables are designed to fit in only one orientation. Insert the plugs into the connectors until they fit in place.

Caution:

The PW1 and PW12 Power Connector must be used simultaneously.

The board requires a minimum of 400 Watt power supply to operate. Your system configuration (amount of memory, add-in cards, peripherals, etc.) may exceed this minimum power requirement. To ensure adequate power, for GLI mode use a 550 Watt or greater power supply.

Page 3-11

Page 27
Image 27
Intel I945P specifications PW1