Intel S875WP1-E manual Installing the Server Board, Placing the Server Board into the Chassis

Installing the Server Board

Placing the Server Board into the Chassis

When placing the board into the chassis, insert the rear I/O connector end first, carefully positioning the board’s I/O connectors into the openings in the I/O shield on the back of the chassis.

TP00103

Figure 9. Placing the Server Board into the Chassis

Attaching the Server Board

✏NOTES

You will need a Phillips (#2 bit) screwdriver.

Refer to Page 107 for regulatory requirements and installation instructions and precautions.

The Intel® Server Chassis SC5200 and the Intel Server Chassis SC5250-E use different screws to attach the server board to the chassis. Be sure to use the appropriate screw for your chassis. See the diagram below for the correct screw for each chassis.

WARNING

Only qualified technical personnel should attempt this procedure. Disconnect the server from its power source before performing the procedures described here. Failure to disconnect the power before you open the server can result in personal injury or equipment damage.

44 Intel Server Board S875WP1-E Product Guide