Intel S875WP1-E manual Peripheral Configuration Submenu continued

Table 22. Peripheral Configuration Submenu (continued)

Feature	Options		Description
Parallel Port	•	Disabled	Configures the parallel port.
	•	Enabled	Auto assigns LPT1 the address 378h and the
	•	Auto (default)	interrupt IRQ7.
			An * (asterisk) displayed next to an address indicates a
			conflict with another device.
Mode	•	Output Only	Selects the mode for the parallel port. Not available if the
	•	Bi-directional	parallel port is disabled.
		(default)	Output Only operates in AT-compatible mode.
	•	EPP	Bi-directional operates in PS/2-compatible mode.
	•	ECP	EPP is Extended Parallel Port mode, a high-speed
			bi-directional mode.
			ECP is Enhanced Capabilities Port mode, a high-speed
			bi-directional mode.
Base I/O Address	•	378 (default)	This feature is present only when Parallel Port is set to
	•	278	Enabled
			Specifies the base I/O address for the parallel port.
Interrupt	•	IRQ 5	This feature is present only when Parallel Port is set to
	•	IRQ 7 (default)	Enabled
			Specifies the interrupt for the parallel port.
DMA	•	1	This feature is present only when Parallel Port Mode is set
	•	3 (default)	to ECP
			Specifies the DMA channel.
10/100 NIC	•	Disabled	Enables or disables the on-board LAN#1 device.
	•	Enabled
		(default)
Gigabit NIC	•	Disabled	Enables or disables the on-board LAN#2 device.
	•	Enabled
		(default)
ATI Rage XL Video	•	Disabled	Enables or disables the on-board ATI* Rage XL video
	•	Enabled	controller.
		(default)
Promise PDC20319	•	Disabled	Enables or disables RAID support.
S150 TX4	•	Enabled
		(default)

Configuration Software and Utilities 75