SECTION
Checking and Tightening Mast Pivot
NOTE: For this procedure, refer to FIGURE 7.5.
1.To gain access to the attaching hardware, remove the covers that are on either side of the mast.
2.Check that the locknut is tight and secure on the screw.
3.If needed, do one or more of the following:
•Tighten locknut and back‐off the locknut 1/8 of a turn.
•Replace the locknut.
Boom
Bushing |
|
| Teflon Bearing |
Teflon Bearing | Nylon Washer |
| |
Nylon Washer | Washer |
| |
Washer |
|
Screw | Cover |
|
| Locknut |
Cover | Mast Connector |
|
NOTE: Lock nuts this side of mast not shown.
Screws
Mast
FIGURE 7.5 Checking and Tightening Mast Pivot
Jasmine™ Patient Lift | 26 | Part No 1150704 |
