PROCEDURE 3

SEAT AND BACK

 

 

S E A T

A N D

B A C K

TRACER DLX (BUILT BEFORE MARCH 13, 2000) - NOTE: There are no pivot links on the Tracer DLX.

a.Pull crossbrace assembly up and away from the main body of the wheelchair. Seat guides will stay attached to rear canes.

b.Remove upholstery screws.

c.Remove crossbraces from seat guides.

3.Remove the hardware that secures the two (2) existing crossbraces together (FIGURE 6).

4.Perform one (1) of the following:

TRACER TITAN/SX/SX RECLINER/DLX (BUILT AFTER MARCH 13, 2000) -

a.Assemblethetwo(2)NEW crossbracestogether. Refer to FIGURE 6 for hardware orientation.

b.Reinstall the button head screws and locknuts that secure the pivot links to the crossbraces.

TRACER DLX (BUILT BEFORE MARCH 13, 2000) -

a. Position the crossbraces onto the seat guide.

5.Slide insert tubes into the wheelchair frame.

6.Align the holes in the insert tube with the holes in the wheelchair frame.

7.Insert the phillips screws and tighten the locknuts securely.

8.Install the NEW back and seat upholstery onto the wheelchair. Refer to REPLACING THE BACK UP- HOLSTERYand REPLACING THE SEAT UPHOL- STERY in this section of the manual.

TRACER TITAN, TRACER SX, TRACER SX RECLINER and TRACER DLX (BUILT AFTER MARCH 13, 2000)

Wheelchair

NOTE: orientation of hex screw, spacers, nylon washer, steel washers and locknut (hardware) for instal- lation of new crossbraces.

Crossbrace

Locknut

Locknut

Insert

Tube

Phillips Screw

Frame

Pivot Link

Button Head

Screw

TRACER DLX (BUILT BEFORE MARCH 13, 2000)

NOTE: orientation of hex screw, spacers, nylon washer, steel washers and locknut (hardware) for instal- lation of new crossbraces.

Seat Guide

Wheelchair Frame

 

Crossbrace

Seat Guide

Locknut

Insert

Tube

Phillips Screw

FIGURE 6 - ADJUSTING SEAT WIDTH

22

Page 22
Image 22
Invacare SX Recliner, Tracer Titan, Tracer SX manual Tracer DLX Built Before March 13