Invacare Tracer Titan Heel Loop Replacement Figure, Swingaway Footrest Height Adjustment Figure

PROCEDURE 1 FRONT RIGGINGS

F

R O N T

R

I

G G I N G S

This Procedure includes the following:Swingaway Footrest Assembly InstallationSwingaway Footrest Height Adjustment

Heel Loop Replacement

Elevating Legrest Assembly InstallationAdjusting the Elevating Legrest Assembly

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or dam- age may result.

SWINGAWAY FOOTREST ASSEMBLY INSTALLATION (FIGURE 1)

1.Turn the swingaway footrest to the side (open footplate is perpendicular to wheelchair).

2.Place the hinge plates on the swingaway footrest onto the hinge pins on the wheelchair frame.

3.Push the swingaway footrest towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheel- chair when locked in place.

4.Repeat this procedure for the other footrest assembly.

5.To release the footrest, push the footrest release lever inward, rotate footrest outward.

	Hinge Plate	Footrest
		Release
		Lever
		Swingaway
Hinge		Footrest
Pins		Assembly
	Hinge	Footplate
	Plate

FIGURE 1 - SWINGAWAY FOOTREST

ASSEMBLY INSTALLATION

SWINGAWAY FOOTREST HEIGHT ADJUSTMENT (FIGURE 2)

NOTE: Release the footrest locking mechanism and lift the footrest off of the hinge pins. Lay the assembly on a flat surface to simplify this procedure.

1.Loosen, but do not remove the bolt and locknut that secure the lower footrest assembly to the upper footrest support.

2.Reposition the lower footrest assembly to the desired height.

3.Securely tighten the bolt and locknut.

4.Repeat this procedure for the other footrest, if necessary.

Upper	Bolt and	Lower
Footrest	Locknut
Support		Footrest
		Assembly

FIGURE 2 - SWINGAWAY FOOTREST HEIGHT

ADJUSTMENT

HEEL LOOP REPLACEMENT (FIGURE 3)

1.Loosen, but do not remove the bolt and locknut that secure the lower half of the footrest to the swingaway footrest assembly.

2.Remove the lower footrest assembly.

3.Remove the phillips screw, spacer and locknut that secure the heel loop to the footplate.

4.Remove heel loop from slide tube.

5.Replace heel loop.

6.Reverse STEPS 1-5to reassemble.

NOTE: When securing the heel loop to the footrest as- sembly, tighten the phillips screw and locknut until the spacer is secure.

16