![](/images/new-backgrounds/19952/1995245x1.webp)
TROUBLESHOOTING
I am using the amp for a subwoofer application and it sounds “rubbery”, what’s up?-
•Verify that the Clip Limiters are OFF. See page 21.
•The Clip Limiter is set to respond as quickly as possible after clipping is detected. On low frequency material, this may be perceived as a “rubbery” effect. It may be preferable to turn Clip Limiting off, and let the amp clip occasionally, especially if the speakers are robust.
I am trying to use QSC’s
•Nothing. The PL6.0 II does not supply the required power to the
•An accessory AC adaptor (wall wart) will be required for the
•Make sure the DataPort cable between the amp and the DSP module has pin #9 removed from either end. See DSP module documentation for details.
23