![](/images/new-backgrounds/19952/1995221x1.webp)
SETUP- Operating Mode Selection
Parallel Mode
In Parallel Mode, the channel 1 and channel 2 input connectors are connected in parallel. Applying an input signal to either input will drive both channels. Make sure only one input signal is applied to the ampli- fier when operating in Parallel mode. Each channel still has independent gain control, clip limiting, and output connection, just like Stereo Mode.
To operate in Parallel Mode, set the Mode Switch to PARALLEL. Connect the single input signal and the two speaker channels.
Bridge Mode
In Bridge Mode, both output chan- nels are combined into one higher power channel. The result is one output with about 4 times the peak power and about 3 times the sus- tained power of a single channel. Use only CH1’s input. Output connec- tions for Bridge Mode are the two red binding posts. Connection polarity is clearly marked (CH1 red binding post= positive, CH2 red binding post= negative).
To operate in Bridge Mode, set the |
|
|
|
|
|
| |||
|
|
|
|
|
| ||||
Mode Switch to the BRIDGE position. |
|
|
|
|
|
| |||
Connect the single input and the |
| Speakon connectors are not recommended for | |||||||
single speaker channel. |
|
|
|
| |||||
|
|
|
| Bridge mode use! Use binding post outputs. | |||||
|
|
|
|
| Speakons are not wired for Bridge mode output! | ||||
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
11