Knoll 6.0 II Cooling, Amplifier Protection, Load Protection, Weight, Power Requirements, Pin

SPECIFICATIONS- PowerLight 6.0 II Electrical Data

QSControl Control and Monitor Parameters on/standby, channel gain, mute, polarity, input level, output level, heat sink temperature, output load sense, clip detect, protect detect, operating Mode sense (Stereo/Parallel/Bridge)

Cooling	four continuously variable speed fans, rear to front airflow
Amplifier Protection	short circuit, open circuit, thermal, ultrasonic, and RF protection
	stable into reactive or mismatched loads
Load Protection	turn-on and turn-off muting, DC fault power supply shut down
Weight	53 lbs (net), 60 lbs (shipping)
Power Requirements	120 Volts AC, 50 to 60 Hertz, 30 Amp NEMA L5-30 receptacle
	OR
	240 Volts AC, 50 to 60 Hertz, 15 Amp service

Current Consumption	120 Volts
(in amperes, rms)

240 Volts

Current Consumption Notes:	Typical- 1/8 power, pink noise, represents typical program with occasional clipping
	Full- 1/3 power, pink noise, represents severe program with heavy clipping
	Maximum- continuous sine wave at 1% clipping
	Note: Specifications are subject to change without notice.

APPENDIX-

DataPort Pinout

The DataPort connection is QSC-specific. Informa- tion is subject to change.

Pin Signal Description

1Ch. 1 Minus (-) Input Signal

2AC Standby Control

3V- MON Ch. 1 and Subcode 1

4I- MON Ch. 1 and Subcode 2

5Clip/Protect Ch. 1

6Hard Ground

7Ch. 1 Plus (+) Input Signal

8Ch. 2 Plus (+) Input Signal

9+15V from Amplifier

10Data Reference Ground

11Ch. 2 Minus (-) Input Signal

12Amplifier IDR (Model ID)

13V- MON Ch. 2 and Subcode 3

14I- MON Ch. 2 and Subcode 4

15Clip/Protect Ch. 2

25