USE- AC Power Switch and LED Indicators
AC Power Switch
On the left side of the front panel is the Power switch. The switch is labeled ON, above it and to the right.
To turn the power on: Press in on the upper portion of the rocker switch. The amplifier will go through its
To turn the power off: Press in on the bottom portion of the rocker switch. It may take a few moments for the Power LEDs to extinguish. This is normal.
LED Indicators for Power Status
To the right of the Power switch are six LEDs indicating the Power Status of the amplifier. The left column of LEDs is for channel 1 and the right column for channel 2.
POWER- green LED indicating the amplifier is turned on and con- nected to a properly functioning AC source.
STANDBY- yellow LED, illuminates when the amplifier is put into Standby mode by DataPort or Power Supply Remote Control connec- tor.
PROTECT- red LED, illuminates when the amplifier goes into protec- tive muting. This could be caused by shorted wiring or speakers, overheating, or amplifier failure. See Troubleshooting section.
19