Knoll 6.0 II user manual SETUP- Operating Mode Selection, Stereo Mode

SETUP- Operating Mode Selection

Operating Mode Selection

The operating Mode selection switch determines how the inputs are routed to the two amplifier channels and how the outputs are connected to the speakers.

The Mode selection switch is located on the rear panel, left bottom corner. It is a three-position slide-switch. The switch is recessed to prevent accidental changes. Change switch positions by sliding the switch up or down. Operate the switch with a small, flat-tip screwdriver or similar tool. Do not use a pencil or other item that could break off and fall into the chassis.

Stereo Mode

In Stereo Mode, each input signal is sent to its respective channel. Each channel has independent gain control, clip limiting, and output connection.

To operate in Stereo Mode, set the Mode Switch to STEREO. Connect the two input signals and the two speaker outputs.

10