Invacare TDX SI manual Wheelchair Operation Description, Driving Screen

SECTION 5—WHEELCHAIR OPERATION

ITEM	DESCRIPTION
STATUS INDICATOR	The status indicator will show a “Warning” (exclamation point inside a triangle)
	indicator when the chair has a condition that requires attention.
	The status indicator will show a “STOP” sign when a serious condition exists. The
	chair will not be allowed to operate.
	The status indicator shows an Attendant Icon if the attendant’s override switch is
	active.
MODES	The dotted-box shows the area that contains the available “modes” in the cur-
	rently selected drive. The modes are programmed for each drive and are based
	upon the configuration of the chair.
	These modes are highlighted when the Mode is active. The operator changes
	modes by pressing the Mode Select Switch.
	The available modes are as follows:
	Drive Mode (1 through 4)
	Automatic Positioning
	Actuator Control Switch Mode (4-switch, 4-switch 2 levels, etc.)
	ECU Output Activated (1 through 4)
	RIM Mode Activated
	Drive Select Mode Activated
	No Driving

Available Modes in	Drive Profile Name
	Drive Indicator	Battery Gauge Display
this Drive (Must be

Programmed)

Icon appears when a joystick command will drive the wheelchair

Status/Info Message Area ECU Status Indicator

FIGURE 5.6 LCD Display Screens - Main Screen

Driving Screen

NOTE: For this procedure, refer to

FIGURE 5.7.

This screen is shown when the operator issues a drive command and the Drive Icon on the main screen was highlighted.

NOTE: The Drive’s name, warning/info
message, status icon and battery indicator are
displayed on this screen.	FIGURE 5.7 LCD Display Screens - Driving
	Screen

TDX® SI, TDX SI-HD 40 Part No 1154294