Installing Batteries into Wheelchair | Invacare TDX SI specs

SECTION 10—BATTERIES

5.Slide the battery tray into the wheelchair (FIGURE 10.3).

6.Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery Retention Bracket and Rear Shroud on page 58.

Battery with Battery	DETAIL “A”
Connector Bracket

Front of the Battery Tray

NOTE: 22NF Batteries shown.

Battery Stop

Rear of the Battery Tray

DETAIL “B”	DETAIL “C”
Connect Front
Battery to
Rear Battery
HERE	Battery
	Battery
Front	Straps
Battery
Rear Battery

FIGURE 10.4 Installing Batteries into Wheelchair

Installing the Front Shroud/Battery Retention Bracket and Rear Shroud

WARNING

Wheelchairs with TRRO or TRBKTS Only - Battery retention brackets MUST be installed at all times. Otherwise, the wheelchair will not be WC/19 compliant.

After installing front shroud, ensure that the mounting screws on the front shroud/ battery retention bracket are fully engaged into the battery box.

NOTE: For this procedure, refer to FIGURE 10.2 on page 56.

1.Reinstall the front shroud/battery retention bracket onto front of wheelchair frame.

2.Install two mounting screws on the sides of the front shroud/battery retention bracket.

WARNING

When installing batteries, ensure battery connector is securely engaged to the controller connector - otherwise serious personal injury may result.

3.Wheelchairs with Footboards Only: Using the mounting screw and washer, secure the footboard support to the wheelchair frame.

4.Connect the controller to the batteries at the rear of the wheelchair.

TDX® SI, TDX SI-HD

58

Part No 1154294

Image 58

Invacare TDX SI manual Installing Batteries into Wheelchair

Contents

TDX SI TDX SI-HD Reference Documents Reference DocumentsManual Table of Contents Safety INSPECTION/TROUBLESHOOTING Wheel Locks Register Your Product Transport Ready Package Trro Special Notes Special NotesMeaning Trro and Trbkts Warnings Wheelchairs with 22NF Batteries Label LocationsAll Wheelchairs Label Locations Wheelchairs with Trro Wheelchairs without Trro Typical Product Parameters Typical Product ParametersTDX SI HD Operation Information Repair or Service InformationGeneral Guidelines General Guidelines General Guidelines Wheelchairs with Trro or Trbkts Only ElectricalGrounding Instructions Batteries Charging Batteries Weight Limitation Weight TrainingRain Test EMI Information EMI Information EMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance SAFETY/HANDLING of Wheelchairs Stability Assist Coping with Everyday Obstacles Reaching, Leaning and Bending Forward Reaching, Leaning and Bending Reaching, Bending Backward Pinch Points Stairways Transferring To and From Other Seats Transferring To and From Other Seats Inspect/Adjust Initially Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Safety INSPECTION/TROUBLESHOOTING Inspect/Adjust Weekly Inspect/Adjust Monthly Inspect/Adjust Every 18 Months Troubleshooting MechanicalInspect/Adjust Periodically Inspect/Adjust Every 2 Years SPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks Troubleshooting ElectricalInformation Gauge Display Diagnostics Display Description Definition Symptom Probable Cause Solutions Service Indicator Light DiagnosticsPossible Solution MPJ+, PSR+, PSF+ Joysticks or Displays BAD Joystick CAL Values Checking Battery Charge Level DON’T Wheelchair Operation Turning the Power On/OffUsing the Joystick to Drive the Wheelchair Operating the Wheelchair Movement Action Wheelchair On/Off Button Speedometer Joystick Service IndicatorSpeed Control Buttons Charger/Programming Input Selecting the Drive Mode MPJ+ Joystick Switches and IndicatorsDrive Select Toggle Switch Information Gauge Display Speed Control LCD Display Screens Splash Screen Main Screen Wheelchair Operation Description Driving Screen Remote Mode Reset Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Stop Switch Connected Devices Screen Mode Switch Remote On/Off SwitchMemory Card Slot Repositioning Joystick Van Seats Disconnecting Disconnecting/Connecting the JoysticksAdjustable Asba Seats SPJ+ Joysticks Connecting MPJ+ Joysticks Disengaging/Engaging Motor Lock Levers Motor LocksMotor Locks Engaging Wheel LocksDisengaging/Engaging the Wheel locks Disengaging Installing Footboard AssemblyRemoving/Installing the Footboard Pinch point may occur when rotating the footboard assembly Adjusting the Footboard Angle Removing/Installing the Footboard Forks Adjusting ForksForks Batteries Batteries Using the Proper Batteries For Wheelchairs Using 22NF Batteries Wire Cutter Replacing Batteries Replacing Batteries Cleaning Battery Terminals Removing/Installing the Batteries From/Into the Wheelchair Battery Retention Bracket Installing Batteries into Wheelchair Removing the Batteries from Wheelchair Installing Batteries into Wheelchair SPJ+, SPJ+ w/PSS and SPJ+ w/ACC Joysticks When to Charge BatteriesMPJ+ Joystick Description and Use of Battery Chargers Charging Batteries Required Items Tool Quantity Transport Ready Package Trro Transport Ready Package Trro About Transport Ready Packages Compliance Information Securing the Wheelchair to the Vehicle SpecificationsMotor Wheelchair Weight Limit Positioning the Wheelchair in the Vehicle Securing the Wheelchair Securement Points Securing the Occupant Wheelchair-Anchored Belts Wheelchair-Anchored Belts Vehicle-Anchored Belts Rating Description Seating System Positioning Belts TDX SI, TDX SI-HD Limited Warranty Global Limited Warranty Excluding Canada Limited Warranty Canada Limited Warranty USA