SECTION 10—BATTERIES

Removing the Batteries from Wheelchair

NOTE: For this procedure, refer to FIGURE 10.3.

1.Slide battery tray with batteries out.

2.Disconnect the battery straps.

3.Unplug front battery from rear battery.

4.Remove the front battery.

5.Slide the rear battery forward and remove it from the tray.

FRONT OF WHEELCHAIR

Rear Battery

Disconnect Front Battery

from Rear Battery Here

Front Battery

Battery Straps

Battery Tray

FIGURE 10.3 Removing the Batteries from Wheelchair

Installing Batteries into Wheelchair

NOTE: For this procedure, refer to FIGURE 10.3 and FIGURE 10.4 on page 58.

NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base. Illustrations in FIGURE 10.4 on page 58 are shown without the wheelchair for clarification purposes only.

1.Position the battery with battery connector bracket in the rear of the battery tray in the orientation as shown. See Detail “A” of FIGURE 10.4 on page 58.

NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the opposite end.

NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller or each other.

2.Position the remaining battery in the front of the battery tray in the orientation shown so that the wiring harnesses can be connected together. See Detail “B” of FIGURE 10.4 on page 58.

3.Connect front battery to rear battery. See Detail “B” of FIGURE 10.4 on page 58.

4.Connect battery straps. See Detail “C” of FIGURE 10.4 on page 58.

Part No 1154294

57

TDX® SI, TDX SI-HD

Page 57
Image 57
Invacare TDX SI manual Removing the Batteries from Wheelchair, Installing Batteries into Wheelchair