Figure 10. Removing the Bottom Panel

2.Remove the screw that holds the bottom panel in place (Figure 10).

3.Slide the bottom panel toward the rear of the system until the two tabs at the bottom front of the system clear their slots.

4.Remove the bottom panel from the chassis.

Board Installation

Follow this procedure to install an add-in board.

1.Run any software that is required before installing the board:

∙If you are installing an ISA add-in board that does not comply with the Plug and Play specification, you will need to configure it manually, using the Windows 95 Add New Hardware Wizard. See your Windows 95 documentation for more information.

∙If you are installing an ISA or PCI add-in board that complies with the Plug and Play specification, the board is ready to install.

22 Advantage! 9000 Series User’s Manual